Laars Ignitor, Hot Surface, w/Gasket
Used on the following models:
PNCH0500, PNCH500, PNCH0750, PNCH750, PNCH1000, PNCH1250, PNCH1500, PNCH1750,
PNCH2000, PNCV0500, PNCV500, PNCV0750, PNCV750, PNCV1000, PNCV1250, PNCV1500,
PNCV1750, PNCV2000, PNCP0500, PNCP500, PNCP0750, PNCP750, PNCP1000, PNCP1250,
PNCP1500, PNCP1750, PNCP2000.
The igniter is a “glow bar” type silicon carbide unit. It is
energized whenever there is a call for heat and the red
"IGNITER" light on the boiler control is lit. After the igniter is
switched off and the boiler continues to run, the igniter functions
as a flame sensor for the boiler control.
If the ignitor fails and must be replaced, always install a new
igniter gasket with the replacement igniter.
CAUTION: Ignitor gets hot.
Pennant, Ignitor, Hot Surface, w/Gasket, 500-2000
|
